Dixon 2960606C Includes

• (1) Push-On Hose Mender, Hose ID 3/8″, Brass, 2.05″ L

Dixon 2960606C Features

• No hose clamps or ferrules are needed
• Trim hose end with smooth square cut
• Lubricate either push-on fitting, hose or both
• Insert push-on fitting into hose until first barb is in hose
• Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from end
• Push with a steady force until end of hose is covered by yellow plastic cap
• 0.92″ L Barb
• No hose clamps or ferrules are needed
• Dixon push-on fittings are intended for use with Lok-On (push-on style) hose only
• Caution: push-on fittings will properly grip push-on hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap
• Warning: this product contains a chemical known to the state of California to cause birth defects or other reproductive harm
• Do not use in connection with drinking water
• Wash hands after handling

Dixon 2960606C Specifications

Material Brass Component Material Yellow Plastic Cap Hose ID 3/8″ Length 2.05″ Pressure Rating 350 PSI Temperature Range -40 to +150F Weight 0.0510 lbs Number of Barbs 2 Barb Length .92″ Dimensions 2.05″ L Nominal Size 3/8″ Fitting/Connector Type Mender